Modeling Results

The model can be configured by filling in many parameters, which leads to endless combinations. Below, a few of these possibilities are displayed and will be discussed. These data will lead to a concrete outcome that can be compared to our result in the lab and may give more information on how to improve our biosensor.

Linker Simulation

The relation between the intracellular linker length & the distance between the COMBs

The linker was simulated using a Monte Carlo method. Two membrane proteins were virtually placed on a 2d membrane. Then the linkers connecting the membrane proteins to their corresponding intracellular domain were simulated (For more information, check the approach page). The results for different distances between the membrane proteins are shown in figure 1. These histograms show that for small distances between two membrane proteins, the linker has a strong effect on the distance between the intracellular domains. For larger distances between the membrane proteins, the effect is less.

Furthermore, in the last case the effect of the linker on the intracellular distance is more even, almost symmetrical, whilst for a small distance between the membrane proteins, the linker will almost always increase the distance between the intracellular domains.

The relation between BRET or FRET efficiency and the intracellular linker length

These distances were converted into BRET or FRET efficiencies, to check the linker’s effect on these. Figure 2 shows the effect of the linker on the BRET and FRET efficiency. It shows that for small distances between two membrane proteins, which is for example the case when the clicked aptamers are bound to thrombin, the linker causes a lower BRET and FRET signal, while for larger distances it shows a slight increase in signal intensity.

This graph shows the BRET or FRET efficiency as function of the distance between the involved membrane proteins, for different linker lengths.

System Simulation

The relation between extracellular ligand binding and BRET or FRET signal

To estimate how well our sensor works, the increase in BRET or FRET signal on ligand binding was modeled. First the BRET or FRET signal resulting from the binding of aptamers is modeled, using Smoldyn. Then the BRET or FRET signal from the interaction between the unbound membrane proteins is added. This signal is divided by the amount of BRET or FRET found when only unbound membrane proteins are modeled.

Two concentrations of the construct were modeled. The results are depicted in figure 3. It shows that lesser membrane proteins will results in a higher relative signal increase. However, the optimal amount of membrane proteins is also dependent on the absolute signal, as a lower amount of membrane proteins will also lead to a decreased absolute signal, which is more difficult to detect .