Difference between revisions of "Team:William and Mary/Interlab Study"
| Line 149: | Line 149: | ||
<br> | <br> | ||
We assembled the gBlocks using our <a href = "https://2015.igem.org/Team:William_and_Mary/Protocols:Gibson">Gibson assembly protocol</a>, and imaged the constructs using our <a href = "https://2015.igem.org/Team:William_and_Mary/Protocols:Imaging">imaging protocol</a>.</p> | We assembled the gBlocks using our <a href = "https://2015.igem.org/Team:William_and_Mary/Protocols:Gibson">Gibson assembly protocol</a>, and imaged the constructs using our <a href = "https://2015.igem.org/Team:William_and_Mary/Protocols:Imaging">imaging protocol</a>.</p> | ||
| − | < | + | <p>Our data are listed in the table below:<p> |
| − | Our data are listed in the table below: | + | |
<p><img src = "https://static.igem.org/mediawiki/2015/b/ba/WMIntegratorDiagram.png" width = 700> | <p><img src = "https://static.igem.org/mediawiki/2015/b/ba/WMIntegratorDiagram.png" width = 700> | ||
Revision as of 23:20, 18 September 2015
Interlab Study We participated in the Interlab Measurement Study! We created are fluorescent constructs using DNA synthesis and Gibson Assembly. The constructs we measured were J23101 + I13504, J23106 + I13504, and J23117 + I13504. Results are reported below. After we transformed our constructs into cells, we inoculated individual colonies in separate inoculation tubes. We then performed a series of spins and washes to remove the LB media and resuspend the cells in water. Finally we imaged them and obtained fluorescence values using confocal microscopy. In order to analyze the data, we applied a binary definition of what a cell was to our confocal images. We confirmed that the binary definition was picking up as many of the cells on the image as was reasonably possible. Our software determined the average fluorescence measurement for all the pixels inside the binary 'cells' and we reported the average of these measurements for each sample.
Our data are listed in the table below:
We assembled the gBlocks using our Gibson assembly protocol, and imaged the constructs using our imaging protocol.
