Experiments and protocols

A majority of the protocols we used originate from the book "Synthetic biology-A lab manual", written by Anthony Forster, Erik Gullberg and Josefine Liljeruhm. They can therefore not be published here. The following protocols from the sixth chapter of this book were used:

1. 0.9% NaCl
2. 50% Glycerol
3. 1M CaCl₂
4. 10x TBE Buffer
5. SOB Medium
6. LB Medium
7. LB Agar Plates and Addition of Antibiotics
8. Overnight Cultures with antibiotics, and glycerol stocks
9. Agarose gel electrophoresis
10. Preparation of competent E. coli cells using CaCl₂
11. Transformation of CaCl₂ competent E. coli cells
12. Bacterial re-streak techniques
13. Digestion with DpnI
14. 3A assembly
15. Colony PCR

We also used several other protocols which we share below.

Biosurfactant characterization protocols

Drop collapse test

Materials required: 50mm petri plates, stop watch, olive oil and bacterial culture

Method:

1. A 50mm petri plate was covered with 600µl of olive oil.
2. In the centre of the plate, small drops of either 50 or 100µl of bacterial culture were placed.
3. The drop was observed for eventual collapse and the diameter of the drop was measured after 0, 5, 10, 15 and 20 min.
4. A collapsed drop indicate that the presence of biosurfactants.

Thin Layer Chromatography

Materials required: Bacterial culture, 0.45 syringe filter, ethyl acetate, ethanol, chloroform, methanol, acetic acid, orcinol, sulphuric acid, hot air oven , vacuum centrifuge and TLC silica plates

Sample preparation:

1. Overnight bacterial culture was centrifuged 10000rpm for 10 minutes.
2. Supernatant of the samples were filtered using 0,45 μm syringe filter.
3. The filtered supernatant was extracted with ethyl acetate in 1:1 v/v ratio three times.
4. The organic solvent was removed by evaporation using vacuum centrifuge overnight.
5. 10 μl 99% ethanol was added to the dried samples which then could be loaded on TLC silica plates