Results

Toehold experiments

In silico testing:

To see an explanation of in silico testing, please visit the . Download raw data files for Zeus NUPACK testing here. Visit the registry page for more information.

Experimental validation of GreenFET1J (BBa_K1586000):

As was explained on the experiments page, GreenJ's (BBa_K1586000) function was characterised and validated by measuring fluorescence intensity of GFP in response to increasing amounts of trigger RNA. Shown in figure 1 is the raw data which was collected from this experiment. In order to analyse this data, the log10 of the amounts of TrigGreen (in nanograms) were calculated. So that the log10 value for 0ng could be calculated, 1x10^-6ng was used instead, and all values were increased by six so that 0ng shows as 0 on the graph. These data were then plotted on a graph and a linear trend-line fitted (figure 2).

On this graph, the point at about 7.72 (52.31 ng) does not match the general trend of the other points, in fact it registers at about the same fluorescence intensity as 0ng of trigger RNA. Due to the low volumes of RNA which were being added to the reactions, this reading could easily be due to a pipetting error and has therefore been left out of any further analysis. A graph without this value and with a newly fitted trend-line is shown in figure 3, as can been seen on the graph, the R² value for this is 0.7247. Also shown is the percentage increase in fluorescence between no trigger and the 2615.23 ng of trigger; 138%.

From this graph, it can be seen that the as the amount of TrigGreen increases, so does GFP fluorescence intensity, hence validating that BBa_K1586000 works as expected.

Further characterisation:

The following parts were further characterised:

Absorbance spectra:

Shown in figure 4 are the absorbance spectra for aeBlue, eforRed, and amajLime between 400nm and 850nm. The peak maxima for these are 595nm, 580nm, and 595nm respectively.