Difference between revisions of "Team:Glasgow/Project/Overview/Repressors"

Summary

Aim: To characterise PhlF and SrpR repressors and their respective repressible promoters for submission to the iGEM registry.


Results Overview:
• K1725000 (PhlF repressible promoter) and K1725020 (SrpR repressible promoter) successfully drive expression of GFP in E. coli.
• K1725042 (phlF expression driven by a lac regulated promoter) represses K1725001 (GFP expression driven by PhlF repressible promoter) GFP expression 83-fold.
• K1725042 (phlF expression driven by a lac regulated promoter) is orthongonal.


Basic Parts submitted:
• BBa_K1725000 – PhlF repressible promoter
• BBa_K1725020 – SrpR repressible promoter
• BBa_K1725040 – phlF encoding PhlF repressor
• BBa_K1725060 – srpR encoding SrpR repressor
• BBa_K1725080 – Promoter (lacI regulated, lambda pL hybrid) with extra NheI site

Introduction

Our genetic circuit needed an inverter, as our UVA sensor turns on transcription, but our circuit needed to turn off transcription when UVA was present. There are suitable several repressor protein/repressible promoter pairs in the iGEM registry such as TetR or LacI, however, they usually come from experimental studies based on existing systems. Recently, Stanton et al. (2014) have identified sixteen prokaryotic TetR-like repressors by genomic mining and designed synthetic repressible promoters (Figure 1A), as with more independently functioning parts, it will be possible to build increasingly complex genetic circuits . By characterising and submitting two new repressors to the registry, based on Stanton et al. (2014) designs, we aimed to demonstrate that this approach could yield efficient parts, thus widening the access to this synthetic technique, which has the potential to create a much larger range of functions for genetic circuits.


To understand how they were able to design synthetic repressible promoters, it is important to understand how promoters and repressors work.Transcription is the process where RNA polymerase binds to DNA to make mRNA; a promoter tells RNA polymerase where to bind to the DNA, so a promoter is found upstream of a gene. Promoters have -10 and -35 sites that the sigma transcription facter binds to and attracts RNA polymerase, as shown in Figure 1B, transcription starts at +1. If one or both of these sites are bound by another protein, sigma factor cannot recognise the promoter, and transcription does not take place. Transcriptional repressors are proteins that bind to DNA at a specific sequence called the operator sequence. Stanton et al. (2014) overlapped the operator sequence for each repressor over the -10 and/or -35 sites of BBa_J23119, a strong, constitutive Anderson family promoter, meaning when the repressor binds to its operator sequence sigma factor cannot recognise the promoter and transcription cannot start, as shown in Figure 1B.



Figure 1 Synthetic Repressible Promoter Design. A – Synthetic repressible promoters with PhlF and SrpR operator sequences, with -35 and -10 sites shown relative to BBa_J23119, and operator sequence in red capital letters. BioBricks of these promoters include sequence from 5’ end to 3’ end of operator sequence. Image reproduced from (Stanton et al., 2014) B – (i) sturcture of a typical repressible promtoer; (ii) sigma factor binding to -35 and -10 sites to attract RNA polymerase; (iii) repressor protein binding to operator sequence preventing sigma factor binding. Altered from (Alberts et al, 2008)


For a repressor to be useful in a genetic circuit, it must be specific so as not to interfere with another part of the circuit or have unwanted interactions within the cell. Repressors that do this are called orthogonal. Repressor A binds to promoter A; repressor B binds to promoter B; but repressor A cannot bind to promoter B, and vice versa. The sixteen prokaryotic TetR-like repressors Stanton et al., (2014) identified are orthogonal, as shown in Figure 2. In particular, TetR, PhlF, and SrpR do not show significant repression of the other’s repressible promoters.



Figure 2 Orthogonal Repressors. Most orthogonal starting top left corner, decreasing towards bottom right corner. TetR, SrpR, and PhlF indicated by arrows. Image reproduced from (Stanton et al., 2014)


It was decided to make BioBricks of two of the sixteen repressors and characterise them for the iGEM registry. The first repressor we decided to submit as a BioBrick was the PhlF repressor from Pseudomonas protegens Pf-5. In P. protegens PhlF is involved in regulation of the phlACBD operon which synthesises an antifungal metabolite 2,4-diacetylphloroglucinol (PHL). (Sheehan et al., 2000, Abbas et al., 2002) The second repressor was the SrpR repressor from Pseudomonas putida S12. In P. putida SrpR is a regulator of the srpABC operon which is involved in organic solvent tolerance. (Wery et al., 2001, Sun et al., 2011) The aim was to submit and characterise both phlF and srpR and their respective repressible promoters.

Methods

E. coli strains used: TOP10, DH5α, and DS941. Plasmids in Table 1 constructed by BioBrick Standard Assembly, and checked by restriction digest before confirming by sequencing.


Table 1 Composite Parts Assembled. K1725041, K1725061, and R0011.B0032 (for assembly into K1725083) construct synthesised by IDT. K1725062 sequencing showed a deletion in K1725080.


Protocols for CaCl₂ competent cells, transformation, miniprep, restriction digest, gel electrophoresis, ethidium bromide staining, Azure A staining, gel extraction, oligo annealing, and ligation available on our Protocols page. Fluorescence measurements taken as documented on our Interlab Study page.

Results

GFP fluorescence of K1725001, K1725002, K1725021, K1725022, K1725082, and E5504 with plasmid backbone pSB3K3 was measured to compare the relative strengths of promoters K1725000 and K1725020 to a promoter already well documented in the registry, R0040. Figure 3 shows the fluorescence scan image and a graph of approximate molecules of GFP per cell. These results indicated that K1725000 is a significantly stronger promoter than R0040 or K1725020. It also confirms that B0034 is a stronger ribosome binding site that B0032. Due to this, promoters driving expression of GFP with B0034 ribosome binding site were used for characterisation of the repressors.



Figure 3 Characterising Promoters. All constructs with pSB3K3 plasmid backbone, in DH5α cells. Replicates of constructs and controls from three colonies, under the same conditions. Mean and standard deviation of replicates were calculated to give value and error bars.


To test if our repressors were orthogonal, a smaller version of the cross-talk table Stanton et al., (2014) created was emulated, and our expected results are shown in Figure 4. For example, K1725042 is expected to repress GFP expression from K1725001 so these cells should not fluoresce, however, it is not expected to repress GFP expression from K1725021 so these cells should fluoresce green. In order to transform two different plasmids into the same cell, they must have different origins of replication, and different antibiotic resistances so both plasmids can be selected for. It was decided to keep K1725042, K1725062, and K1725083 in the high copy number pSB1C3 backbone, and move K1725001, K1725021, and K1725082 into the lower copy number pSB3K3 backbone.



Figure 4 Expected GFP fluorescence of cells containing plasmids of repressor BioBricks with pSB1C3 backbone, and promoter BioBricks with pSB3K3 backbone. Cells with bold border shown in detail below: K1725042 represses K1725001; K1725042 does not repress K1725021


As shown in Figure 5, K1725083 represses GFP expression from K1725082, but not from K1725001 or K1725021. Similarly, K1725042 represses GFP expression from K1725001, but not from K1725082 or K1725021, as expected. K1725062, however, was not observed to repress any of the three promoter constructs. Sequencing of K1725062 showed a deletion in the promoter, K1725080, suggesting K1725060 was not being expressed. Furthermore, K1725063 (K1725061 driven by promoter K1725000) has been observed to repress expression driven by the K1725020 promoter (more detail on our Bistable Switch page). This supports the hypothesis that K1725062 should be capable of repressing GFP expression from K1725021. Unfortunately, due to time constraints, it was not possible to reconstruct K1725062 and repeat this experiment.



Figure 5 Characterising Repressors. Repressor constructs in pSB1C3 backbone; promoter driving GFP constructs in pSB3K3 backbone; in DS941 cells. The DS941 genotype can be found on our Protocols page. Cells were grown overnight in 100μM IPTG, to induce expression of the repressor proteins. Three replicates of the sample were diluted and tested under the same conditions for each sample. Mean and standard deviation of replicates were calculated to give value and error bars.


In addition to showing that K1725042 and K1725083 were capable of repressing K1725001 and K1725082, respectively, quantification of repression of GFP expression was calculated. Figure 6 shows that K1725082 represses K1725083 GFP expression by 33-fold, whereas K1725042 represses K1725001 GFP expression by 83-fold.



Figure 6 Fold Repression. Repressor protein expression induced with 100μM IPTG. Values and error bars from experiments described above.


To further characterise K1725042 and K1725083, the concentration of IPTG used to induce repressor expression was reduced to investigate the range of regulation of GFP expression. Figure 7 shows that K1725083 has a wider range of regulation, whereas K1725042 shows no significant difference between 100μM and 10μM IPTG.



Figure 7. Repressor constructs with pSB1C3 backbone; promoter driving GFP constructs with pSB3K3 backbone; in DS941 cells. Cells were grown overnight in 100μM, 30 μM, 10 μM, 3 μM, and 0 μM IPTG, to induce expression of the repressor proteins. Three replicates of the sample were diluted and tested under the same conditions for each sample. Mean and standard deviation of replicates were calculated to give value and error bars.

Conclusion

New Basic Parts, BBa_K1725000 (PhlF repressible promoter), BBa_K1725020 (SrpR repressible promoter), and BBa_K1725040 (phlF encoding PhlF repressor) were successfully characterised, and submitted to the iGEM registry. BBa_K1725060 – (srpR encoding SrpR repressor) was characterised on our Bistable Switch page.


K1725000 drives expression of GFP in the BioBricks K1725001 and K1725002, and is significantly stronger than our control promoter, R0040. K1725020 drives expression of GFP in the BioBricks K1725021 and K1725022, and is of equivalent strength to our control promoter, R0040, when both were coupled with the strong Ribosome Binding Site, B0034. K1725040 successfully represses K1725000 driven GFP expression 83-fold, and does not repress promoters K1725020 or R0040.


The next steps in characterisation of our repressor BioBricks would be to construct the BioBrick K1725062 (by insertion of the lacI regulated promoter, K1725080, upstream of K1725061, in order to express the repressor protein) then to repeat our fluorescence experiments to characterise K1725060 further.

References

Abbas, A., Morrissey, J.P., Marquez, P.C., Sheehan, M.M., Delany, I.R., and O’Gara, F. (2002). Characterization of Interactions between the Transcriptional Repressor PhlF and Its Binding Site at the phlA Promoter in Pseudomonas fluorescens F113. J. Bacteriol. 184, 3008–3016.

Alberts et al (2008). Molecular Biology of the Cell (Garland Science, Taylor and Francis Group). Chapter 7, p337-434

Buckley, A. Petersen, J. Roe, A. Douce, G. Christie, J. (2015). LOV-based reporters for fluorescence imaging. Current Opinion in Chemical Biology. 27 (1), p39–45.

Sheehan, M.M., Delany, I., Fenton, A., Bardin, S., O’Gara, F., and Aarons, S. (2000). Regulation of production of the antifungal metabolite 2,4-diacetylphloroglucinol in Pseudomonas fluorescens F113: genetic analysis of phlF as a transcriptional repressor. Microbiology 146, 537–546.

Stanton, B.C., Nielsen, A.A.K., Tamsir, A., Clancy, K., Peterson, T., and Voigt, C.A. (2014). Genomic mining of prokaryotic repressors for orthogonal logic gates. Nat. Chem. Biol. 10, 99–105.

Sun, X., Zahir, Z., Lynch, K.H., and Dennis, J.J. (2011). An Antirepressor, SrpR, Is Involved in Transcriptional Regulation of the SrpABC Solvent Tolerance Efflux Pump of Pseudomonas putida S12. J. Bacteriol. 193, 2717–2725.

Wery, J., Hidayat, B., Kieboom, J., and Bont, J.A.M. de (2001). An Insertion Sequence Prepares Pseudomonas putida S12 for Severe Solvent Stress. J. Biol. Chem. 276, 5700–5706.

Read More!

Protocols

Bioluminesence

Terminator

UVA